ConvertaLift – Will it work on my spa?

IntroHeading

Will it work on my spa?

REQUIREMENTS FOR INSTALLING A
VACUSEAL LIFTER or a SPAEASE 200 LIFTER
On a Hot Tub or a Swim Spa

  1. The radius of any spa corner where a Mounting Bracket is to be installed
    must be 16” or less. (See Fig 1)
    Radius corners from 13” to 16” require and Extension Bracket. (See Fig 2)
  2. On the side where your cover is raised you need a rear clearance of at least 7” on a SpaEase 200 Lifter and 9” on a VacuSeal Lifter. (See Fig 3)
  3. For Installing Mounting Brackets on a SpaEase 200 or a VacuSeal Lifter
    A) A flat level cabinet surface of 4” x 24” is required for proper attachment. (See Fig 4)
    B) A Side Clearance from the cabinet of 3.5” is required.
    a. For the ConvertALift the Side Clearance becomes 5”.
    C) A Clearance below the spa coping of 4” is required. (See Fig 4)
    a. For the ConvertALift the Clearance becomes 14”. (See Fig 5)

SIZE REQUIREMENTS FOR HOT TUBS

  1. For Standard Cover Sizes both sides must be 96” or less. But the “B” Side must be greater than 63”. (See Fig 6)
  2. For Spas longer than 96” but not greater than 132” (11’) a Tri-Fold Cover can be used on a VacuSeal Cover only. (See Fig 7)

SIZE REQUIREMENTS FOR SWIM SPAS

  1. The maximum width is 96” and the maximum length is 264” (8’ x 22’).
  2. If the swim spa is longer than 192” (16’) a Tri-Fold Cover is required on one or both sides. (See Fig 8)

Fig 1

CornerRadius

Fig 2

Screen Shot 2022-06-13 at 3.40.05 PM

Fig 3

vsSE200Clear

Fig 4

ClearVS

Fig 5

ClearanceCLS

Fig 6

squarecorners-spaease

Fig 7 (Tri-Fold Cover Animation for Hot Tub)

Fig 8 (Tri-Fold Cover Animation for Swim Spa)